beautypg.com

Rockwell Automation 1408-EMxx PowerMonitor 1000 Unit User Manual

Page 56

background image

56

Rockwell Automation Publication 1408-UM001D-EN-P - September 2013

Chapter 5 Explicit Messaging

3. Choose the communication type and then set the path and

communication method.

4. Click OK to complete the message setup.

RSLogix5000 Software – Message Setup Using CIP Generic

The following example shows how to set up your message instruction to read or

write to a data table in the power monitor using a CIP Generic message type for

RSLogix5000 software. This setup applies to ControlLogix and CompactLogix

programmable logic controllers. The CIP Generic message type does not support

single element reads or writes. In this example, we are reading the Voltage, Amps,

and Frequency data table from the power monitor.

Communication Type

Path

Method

Ethernet

Port (always 2 for Ethernet), power monitor IP

Address>

CIP

Serial communication

CIP

This manual is related to the following products: