beautypg.com

Set up the powermonitor 1000 unit, Use optional software – Rockwell Automation 1408-EMxx PowerMonitor 1000 Unit User Manual

Page 15

background image

Rockwell Automation Publication 1408-UM001D-EN-P - September 2013

15

PowerMonitor 1000 Overview Chapter 1

EtherNet/IP Protocol

The power monitor supports the EtherNet/IP protocol for communicating via

Ethernet or EtherNet/IP drivers in RSLinx Classic software, or when using

explicit messages from Rockwell Automation controllers communicating via

Ethernet or EtherNet/IP network.

Modbus TCP Protocol

Modbus TCP protocol is also supported for communicating via Modbus TCP

for communication.

Set Up the PowerMonitor

1000 Unit

Although the power monitor ships from the factory with default settings, you

need to configure it for your particular requirements. You may configure the

power monitor using the LCD, the HyperTerminal communication tool, a Web

interface, or other software. This section describes, in general, methods for setting

up the power monitor.

Use Optional Software

RSPower, RSPowerPlus, and RSEnergyMetrix software (with the RT option)

provide configuration interfaces for the power monitor, including the ability to

upload, edit, download, and back up the unit configuration on a personal

computer or server. Please refer to the applicable software user documentation or

help files for information on configuring the power monitor using RSPower,

RSPowerPlus, or RSEnergyMetrix software. Contact your local Rockwell

Automation sales office or distributor, or visit http://

www.rockwellautomation.com/rockwellsoftware/ for more information on

available software packages.

TIP

When configuring Ethernet communication, you should verify

that IP addresses do not conflict with the existing

infrastructure, and that subnet masks and gateways are

properly set.

This manual is related to the following products: