Rockwell Automation 1408-EMxx PowerMonitor 1000 Unit - Manual (Page 23)

Rockwell Automation Publication 1408-UM001D-EN-P - September 2013 23
PowerMonitor 1000 Overview Chapter 1
2. Click Configure Options to access the setup menus.
3. Every time you change a setting or configuration you need to enter the
power monitor’s password (default = 0).
If an incorrect password is entered, the following message appears.
If the password is correct but one or more of the set-up parameter values is
out of range, the following message appears.
EXAMPLE You can change the IP address of the power monitor by navigating to
the Ethernet Communication screen.
Enter the password, change the IP address, and save it by clicking
Submit.
Now you can type in the new IP address in your browser and the main
page refreshes using the new address.