Lenze c300 - Manual (Page 96)

Lenze · Controller | Parameter setting & programming · Reference Manual · DMS 1.5 EN · 04/2014 · TD17
96
12 Visualisation with »VisiWinNET®«
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
12 Visualisation with »VisiWinNET®«
This chapter provides information about the Lenze Engineering tool »VisiWinNET®«.
In addition to some basic information, you are provided with information with regard to the use of
»VisiWinNET®« in connection with the "Controller-based Automation" system by Lenze.
»VisiWinNET®«
is a visualisation software for mechanical and systems engineering.
»VisiWinNET®« can be used to create complex visualisation applications, the possibilities range
from classical operate and monitor functions through to sophisticated SCADA systems.
Licensing
The Controllers can be ordered with a factory-set licence which enables the use of »VisiWinNET®«.
The licence level installed can be found in »WebConfig« under: DiagnosticsLicence

Note!
The Controllers 3221 C and c300 can only be accessed by a remote connection via
»VisiWinNET®« as these devices do not have a display interface (DVI).

Online help for »VisiWinNET®«
Here, further information on the use can be found.