Lenze c300 - Manual (Page 179)

13 Parameter reference
13.9 Communication cards: optional interface
179
Lenze · Controller | Parameter setting & programming · Reference Manual · DMS 1.5 EN · 04/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
13.9.1 CAN (MC-CAN2) communication card / CAN interface for Controller c300/p300
This chapter provides a list of all parameters of the communication card and the CAN interface of
the Controllers c300/p300 in numerically ascending order.
The MC-CAN2 communication card ...
• has two CAN connections/interfaces;
• is not supported by the Controllers c300/p300.
The Controllers c300/p300 only support the CAN master functionality.
C1031
C1032
C1033
C1034
C1035

Note!
If a CAN card is replaced, the parameters of the card previously used must be checked
and deviant settings will have to be adjusted!
Parameter | Name:
C1031 | Device: Type key
Data type: VISIBLE_STRING
Index: 23544
d
= 5BF8
h
Identification of the card
 Read access  Write access  CINH  PLC-STOP  No transfer
Parameter | Name:
C1032 | Device: Type version
Data type: VISIBLE_STRING
Index: 23543
d
= 5BF7
h
Version number of the card
 Read access  Write access  CINH  PLC-STOP  No transfer
Parameter | Name:
C1033 | Device: Name
Data type: VISIBLE_STRING
Index: 23542
d
= 5BF6
h
Device name of the card
 Read access  Write access  CINH  PLC-STOP  No transfer
Parameter | Name:
C1034 | Device: Software
Data type: VISIBLE_STRING
Index: 23541
d
= 5BF5
h
Software version of the card
 Read access  Write access  CINH  PLC-STOP  No transfer
Parameter | Name:
C1035 | Device: Hardware
Data type: VISIBLE_STRING
Index: 23540
d
= 5BF4
h
Hardware version of the card
 Read access  Write access  CINH  PLC-STOP  No transfer