Lenze c300 - Manual (Page 44)

Lenze · Controller | Parameter setting & programming · Reference Manual · DMS 1.5 EN · 04/2014 · TD17
44
5 Commissioning the controller
5.7 Error messages (backplane bus)
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
117 Read semaphore timeout for group 2
118 Read semaphore timeout for group 3
119 Write semaphore timeout for group 1
120 Write semaphore timeout for group 2
121 Write semaphore timeout for group 3
136 Configuration error in the I/O module topology.
137 Too many tasks for the processing of I/O modules. Three tasks at the maximum.
138 Device description does not contain a device type
• Contact Lenze
139 Error while writing the initialisation parameters
• Contact Lenze
140 No definition for number of channels in device description
• Contact Lenze
181 Synchronisation of the I/O system incorrect
• Contact Lenze
200 SDO timeout
• Contact Lenze
220 SDO communication error
• Contact Lenze
221 Physical I/O module topology could not be read.
• Contact Lenze
222 I/O system driver could not be opened.
• Contact Lenze
Error number Error text/remedy