Lenze c300 - Manual (Page 40)

Lenze · Controller | Parameter setting & programming · Reference Manual · DMS 1.5 EN · 04/2014 · TD17
40
5 Commissioning the controller
5.5 I/O system 1000 at the backplane bus of a cabinet controller
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

How to configure the I/O modules in the »PLC Designer«:
1. Append the I/O modules used as Devices to the I/O module coupler:
Note: The sequence of the I/O modules in the device tree must comply with the physical
arrangement.
2. View in the device tree/Device view:
• If everything is configured correctly, all modules are marked with the symbol in the
device tree after going online and starting the PLC.
• In the event of an error, i.e. if the configuration deviates from the physical arrangement,
the modules are marked with the symbol.