Lenze c300 - Manual (Page 21)

4 System structure
4.1 Engineering tools
21
Lenze · Controller | Parameter setting & programming · Reference Manual · DMS 1.5 EN · 04/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
»EASY Navigator«: Starting the suitable Engineering tool
The Lenze Engineering software consists of the Engineering tools optimised for the respective
Engineering phase.
The »EASY Navigator« shows the Lenze Engineering tools installed on the Engineering PC. Start the
desired Engineering tool via the corresponding button:
The »EASY Navigator« ...
• simplifies the selection of the Engineering tool, depending on the Engineering phase.
• simplifies starting the desired Engineering tool (depending on the application case).
• makes it possible to select the Engineering tool suitable for the Engineering phase.
The overview displays the respective function of the Engineering tools:
1) For Controllers c300/p300 in preparation
What would you like to do? Button Engineering tool
Programming
• Program the controller
• Parameterise/commission the Servo-Inverter i700
• Parameterise the I/O system 1000
»PLC Designer«
Parameterising/configuring the inverter
• Parameterise and configure the automation/drive
system
• Parameterise Inverter Drives 8400/Servo Drives 9400
»EASY Starter«
Visualization
• Visualise the applications of the automation system
• Create the visualisation/user interface
»VisiWinNET«
Online diagnostics
• Easy online diagnostics of the Controllers (from»EASY
Starter« V1.2) and other Lenze devices
»EASY Starter« 1)
(Reading parameters)
Online parameterisation
• Online parameterisation/commissioning of Lenze
devices
• Direct online parameterisation with an active online
connection to the Lenze devices
»EASY Starter« 1)
(Reading/writing
parameters)
Engineering tools that are not included in the »EASY Navigator«:
Controller parameterisation/diagnostics
• »WebConfig« can be used on the controller without
commissioning (integrated web server).
• By the use of »WebConfig«, the parameters of the
controller can be accessed via web browser.
• »WebConfig« can also be started in the »PLC Designer«.
»WebConfig«
Backup of controller data
• Create data backups
• Restore data after device replacement
• Carry out software update of the Controller
»Backup & Restore«