JUMO 705060 mTRON T - Multifunction Panel 840 Operating Manual - Manual (Page 167)

167
13 Configuration
Batch start
If the "Start program generator" setting is selected for batch start, the user can start the batch
reporting using a digital signal. In addition, the user has the option of starting the corresponding
program generator.
➥ The program generator is started.
Comment
The comment can be sent to the multifunction panel via interface. It can be displayed using the
PC evaluation software PCA3000.
Step Activity
1 Touch the "Start program generator" button.
2 Select the program.
NOTE!
The program generator corresponding to the current batch is started.
Batch 1 starts program generator 1.
to
Batch 9 starts program generator 9.
NOTE!
If a program generator was started successfully, the function of the button "Start program
generator" changes to "Stop program generator".
NOTE!
In the program generator configuration, the "Function" parameter must be set to "Program
generator".
NOTE!
Program generators are not a standard. They are available as extra code for the central pro-
cessing unit.
NOTE!
A comment is deleted again at the end of batch reporting. If it is to be used multiple times,
the user must resend it to the multifunction panel for each instance of batch reporting.
Different texts are available for each of the nine batches.