JUMO 705060 mTRON T - Multifunction Panel 840 Operating Manual - Manual (Page 130)

13 Configuration
130
Parameter
User operating level
The user operating level consists of a maximum of ten visualizations which the user is free to
put together as preferred. Each of the visualizations can be called up individually or in a loop.
 Chapter 7.11 "User operating level", page 79
Home button
The selected visualization is called up if the user touches the button shown below.
Display after reset
Here, the user can configure which visualization is to be shown after the multifunction panel is
restarted. The user operating level will be preferred if it is active.
Active
Parameter Selection/settings Description
User operating
level Process screen Type of visualization
Any visualization
Home
button Process screen Type of visualization
Any visualization
Display after
reset Process screen Type of visualization
Any visualization
Image number 1 Image number (e.g. for process
screens), group number (e.g. for dia-
grams), or Modbus address of the con-
cerned multichannel controller module
(for controller screens)
Active Yes ( ), No ( ) Only active visualizations are included
by the system and can be selected by
the user.
?
?
?
?
NOTE!
Additional settings may be required so that a visualization can also be displayed by the sys-
tem. For example, batches can only be displayed if they are sufficiently configured by the us-
er.