JUMO 705060 mTRON T - Multifunction Panel 840 Operating Manual - Manual (Page 118)

13 Configuration
118
13.2 Selectors
Selectors contain signals that are available for configuration in the multifunctional panel. This
relates to multifunctional panel signals as well as signals originating from other modules (trans-
fer via the system bus).
13.2.1 Analog selector
Multifunction panel signals
The following analog signals of the multifunction panel are directly available for configuring
most functions.
The following integer signals of the multifunction panel are also directly available for configuring
the counters/integrators.
Signals of the modules
All analog signals that are transferred via the system bus are available for configuring the an-
alog inputs of the multifunction panel (even the signals of the multifunction panel itself). The
selector for signal selection is identical to the selector for configuring the NV connections.
 Chapter 13.18.3 "Analog signals (overview)", page 195
13.2.2 Digital selector
Multifunction panel signals
The following digital signals of the multifunction panel are directly available for configuring most
functions.
Category Signal Description
Inactive No signal selected
Analog inputs Analog input 1 to 54 Analog input signal
Analog variables Analog variable 1 to 54 Value of the analog variables
Counter/Integra-
tor Counter/Integrator 1 to 27 Current value of counter or integrator
Counter/Integra-
tor closed Count./Integrator closed 1 to 27 Value of counter or integrator in most recently
completed capture period
NOTE!
If a signal originating from another module is required, this must be selected as an input sig-
nal for an analog input; the analog signal is then used for configuring the function in question.
Category Signal Description
Inactive No signal selected
Integer variables Integer variable 1 to 16 Value of the integer variables
Category Signal Description
Inactive No signal selected
Digital inputs Digital input 1 to 54 Signal of digital input