Allied Telesis AT-S80 - Manual (Page 95)

AT-S80 Management Software User’s Guide
Section I: Using the Menus Interface 95
Modifying a
Dial-in User To change the password or the VLAN assignment of a dial-in user,
perform the following procedure.
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 14 on
page 64.
2. From the Advanced Switch Configuration Menu, type D to select
Dial-in User Configuration.
The Dial-in User Configuration Menu is shown in Figure 20 on page
93.
3. Type type M to select Modify User.
The following prompt is displayed:
Enter dial-in user name >
4. Type the name of the dial-in user that you want to modify.
The following prompt is displayed:
Enter dial-in user password >
5. Type the password of the dial-in user. You may type in a new
password or the existing password.
The following prompt is displayed:
Enter dial-in user dynamic VLAN ID >
6. Type the VID of the dial-in user. You may type in a new VID or the
existing VID.
7. Type Q to select Quit to previous menu and save your changes.