Allied Telesis AT-S80 - Manual (Page 236)

Chapter 21: Basic Switch Parameters
236 Section II: Using the Web Browser Interface
Rebooting a Switch
This procedure reboots the switch and reloads the AT-S80 management
software from flash memory. You can reboot the device if you believe it is
experiencing a problem. Rebooting the switch does not change any of its
parameter settings.
Caution
The switch does not forward network traffic during the reboot
process. Some network traffic may be lost.
To reboot a switch, perform the following procedure:
1. From the Tools folder, select Reboot.
The Reboot Page is shown in Figure 62.
Figure 62. Reboot Page
2. For the Reboot Type, select Normal Reset.This is the default setting.
Note
The two Reboot Type options Reset to Factory Default and are
Reset to Factory Default Except IP Address are described in
“Returning the AT-S80 Management Software to the Factory Default
Values” on page 240.
3. For the Reboot Status, select Start to start the reboot.