Allied Telesis AT-S80 - Manual (Page 143)

AT-S80 Management Software User’s Guide
Section I: Using the Menus Interface 143
Mapping CoS Priorities to Egress Queues
This procedure changes the mappings of CoS priority levels to egress
priority queues. The default mappings are shown in Table 2 on page 141.
This is set at the switch level and applies to all ports. This procedure also
enables and disables QoS.
To change the mappings or to activate or deactivate QoS, perform the
following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 14 on
page 64.
2. From the Advanced Switch Configuration Menu, type S to select
Quality of Service Configuration.
The Quality of Service Configuration Menu is shown in Figure 31.
Figure 31. Quality of Service Configuration Menu
3. From the Quality of Service Configuration Menu, type T to select
Traffic Class Configuration.
Advanced Switch Configuration -> Quality of Service Configuration Menu
[T]raffic Class Configuration
[P]ort Priority Configuration
[Q]uit to previous menu
Command>