Allied Telesis AT-S80 - Manual (Page 195)

AT-S80 Management Software User’s Guide
Section I: Using the Menus Interface 195
Maximum Request.
Sets the maximum number of times that the switch retransmits an EAP
Request packet to the client before it times out the authentication
session. The default value for this parameter is 2 retransmissions. The
range is 1 to 10 retransmissions.
Quiet Period.
Sets the number of seconds that the port remains in the quiet state
following a failed authentication exchange with the client. The default
value is 60 seconds. The range is 0 to 65,535 seconds.
Re-auth Period.
Specifies the time period between periodic reauthentication of the
client. The default value is 3600 seconds. The range is 1 to 65,535
seconds.
Re-auth Status.
Specifies if reauthentication should occur according to the
reauthentication period. The options are Enabled or Disabled.
Current PVID
Displays the current port VLAN identifier or PVID assignment of the
port. You cannot change this value from the Port Based Access
Control Configuration Menu. See Chapter 10, “Virtual LANs” on page
97 for information about assigning a PVID.
Multi-host
Permits you to enable or disable multi-host status.
6. To permit a guest VLAN ID, type G.
The following prompt is displayed:
Enter guest VLAN ID >
a. Type a VLAN ID and then press Enter.
The Port Based Access Control Configuration Menu is updated with
the new guest VLAN ID.
7. To enable 802.1x to support multiple hosts, type O.
The following prompt is displayed:
Enable or disable multi-host status? >
a. Select E to enable multi-host status and D to disable multi-host
status.
The Port Based Access Control Configuration Menu is updated with
the status of the multi-host feature.