Allied Telesis AT-S80 - Manual (Page 293)

AT-S80 Management Software User’s Guide
Section II: Using the Web Browser Interface 293
Modifying Traps
Use this procedure to modify the IP address and the SNMP version of a
trap for an SNMP community.
To modify a trap, perform the following procedure:
1. From the bookmarks on the left side of the page, select SNMP.
The SNMP folder expands.
2. From the SNMP folder, select Trap Setting.
The Trap Setting Page is shown in Figure 83 on page 292.
3. Within the Trap Setting table, select a pull-down menu in the Version
column to the change the SNMP version of a trap that you want to
modify.
Select the SNMP version of the trap by selecting V1 for SNMP version
1 or V2c for SNMP version 2vc.
4. Change an IP address by typing in the new IP address for a particular
community within the Trap Setting table.
Use the IP address format: xxx.xxx.xxx.xxx
5. To activate your changes on the switch click Apply.
The Trap Setting Page is updated.