Allied Telesis AT-S80 - Manual (Page 222)

Chapter 21: Basic Switch Parameters
222 Section II: Using the Web Browser Interface
Setting Up the IP Access List
The procedures in this section describe how to enable or disable the IP
Access List feature on the switch and how to add or remove IP addresses
from the list. See the following sections:
ˆ “Creating an IP Access List” on page 222
ˆ “Deleting an IP Address” on page 224
For background information regarding the IP Access List feature, see
Chapter 15, “IP Access List” on page 183.
Creating an IP
Access List
To create a list of restricted IP addresses, perform the following
procedure:
1. From the book marks on the left side of the page, select System.
The System folder expands.
2. From the System folder, select IP Access List.
The IP Access List Page is shown in Figure 56.
Figure 56. IP Access List Page
3. To set the IP restriction status, select Disable or Enable in the pull-
down menu next to the IP Restriction Status field. Then click Apply.
By default, the IP Restriction Status field is set to Disable.