Allied Telesis AT-S80 - Manual (Page 287)

AT-S80 Management Software User’s Guide
Section II: Using the Web Browser Interface 287
Modifying an SNMP Community
Use the following procedure to modify the name and the access level of an
existing SNMP community. You cannot change the Index entry.
To change the name and access level of a community, perform the
following procedure:
1. From the bookmarks on the left side of the page, select SNMP.
The SNMP folder expands.
2. From the SNMP folder, select Community Table.
The Community Table Page is shown in Figure 81 on page 286.
3. To change the access level of an SNMP community, select the pull-
down menu under the Access column in the Community table for the
community you want to modify. Select Read-Only access or Read-
Write access.
4. To change the community name, type over an existing community
name. Then click Apply.