Allied Telesis AT-S80 - Manual (Page 124)

Chapter 11: Simple Network Management Protocol (SNMP)
124 Section I: Using the Menus Interface
Creating an SNMP Community
The procedures in this section describe how to create, delete, and modify
an SNMP community. See the following procedures:
ˆ “Adding an SNMP Community” on page 124
ˆ “Deleting an SNMP Community” on page 126
ˆ “Modifying an SNMP Community” on page 127
Adding an SNMP
Community
To create an SNMP community, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 26.
Figure 26. Basic Switch Configuration Menu
2. From the Basic Switch Configuration Menu, type N to select SNMP
Configuration.
Main Menu -> Basic Switch Configuration Menu
System [A]dministration Configuration
System [I]P Configuration
S[N]MP Configuration
[P]ort Configuration
[U]ser Interface Configuration
Rapid [S]panning Tree Configuration
[B]andwidth Control Configuration
IP Access [L]ist
Destination MAC [F]ilter
Storm [C]ontrol Configuration
[Q]uit to previous menu
Command>