Allied Telesis AT-S80 - Manual (Page 294)

Chapter 30: Simple Network Management Protocol (SNMP)
294 Section II: Using the Web Browser Interface
Deleting Traps
Use this procedure to delete traps from an SNMP community.
To delete a trap, perform the following procedure:
1. From the bookmarks on the left side of the page, select SNMP.
The SNMP folder expands.
2. From the SNMP folder, select Trap Setting.
The Trap Setting Page is shown in Figure 83 on page 292.
3. In the Trap table, click delete next to the trap you want to delete from
the table.
The Trap Setting Page is updated.