Allied Telesis AT-S80 - Manual (Page 318)

Chapter 34: Dial-in User
318 Section II: Using the Web Browser Interface
Adding a Dial-in User
This procedure explains how to add a Dial-in User on the switch. For each
user, you must assign an user name, password, and a VLAN.
To configure a Dial-in User, perform the following procedure:
1. From the bookmarks on the left side of the page, select Security.
The Security folder expands.
2. From the Security folder, select Dial-in User.
The Dial-in User Page is shown in Figure 91.
Figure 91. Dial-in User Page
3. To create a new user, enter a user name in the User Name field.
You can enter an alphanumeric value of up to 23 characters. Special
characters are permitted.
4. To assign a password to the user name, enter a password in the
Password field.
You can enter an alphanumeric value of up to 23 characters. Special
characters are permitted.
5. Assign the user name to a VLAN, by entering a VLAN to the Dynamic
VLAN field.
Enter a value between 1 and 4,000. Type “0” to ignore this field.
6. Click Add to save the user information.