Allied Telesis AT-S80 - Manual (Page 183)

AT-S80 Management Software User’s Guide
Section I: Using the Menus Interface 183
Configuring Destination MAC Filtering
The procedures in this section describe how to add or remove MAC
addresses from the Destination MAC filtering addresses. See the following
procedures:
ˆ “Setting Destination MAC Filtering” on page 183
ˆ “Removing Destination MAC Filtering Addresses” on page 184
Setting
Destination MAC
Filtering
To add a MAC address to the destination MAC filtering addresses on the
switch, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 4 on page 32.
2. From the Basic Switch Configuration menu, type F to select
Destination MAC Filter.
See the Destination MAC Filter Menu in Figure 44.
Figure 44. Destination MAC Filter Menu
3. To add a destination MAC address filter, type A to select Add MAC
Address.
The following prompt is displayed:
Add MAC Address to filter >
Basic Switch Configuration -> Destination MAC Filter
MAC Address MAC Address MAC Address MAC Address
----------- ----------- ----------- ------------
-----------------------------------------------------
[N]ext Page
[A]dd MAC Address [Q]uit to previous menu
[P]revious Page [R]emove MAC Address
Command>