Allied Telesis AT-S80 - Manual (Page 110)

Chapter 10: Virtual LANs
110 Section I: Using the Menus Interface
Changing Port
VLAN Type
To change the of ports that are assigned to a port-based VLAN on the
VLAN Management Menu, perform the following procedure.
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 14 on
page 64.
2. From the Advanced Switch Configuration Menu, type V to select
VLAN Management.
The VLAN Management Menu is shown in Figure 21 on page 103.
3. Type C to select Change Port VLAN Type.
The following prompt is displayed:
Add member -> Enter port number >
4. Type a port number (or numbers) that is assigned to a port-based
group. Then press Enter.
You can specify ports individually, separated by commas, for example,
2,7,15, as a range of ports separated by a hyphen, for example, 2-4, or
both, for example, 2-7,15,17.
The following prompt is displayed:
Select port VLAN type (1/2) >
5. Type 1 to indicate the ports belong to a port-based VLAN or 2 to
indicate the ports belong to a tagged VLAN.
You can set ports that are assigned to a port-based group to either 1 a
port-based VLAN or 2 a tagged VLAN. However, ports that are not
assigned to a port-base group can only be set to 2 to indicate a tagged
VLAN.
The VLAN management Menu is updated with the new port
assignments.
6. Type Q to select Quit to previous menu and save your changes.