Allied Telesis AT-S80 - Manual (Page 290)

Chapter 30: Simple Network Management Protocol (SNMP)
290 Section II: Using the Web Browser Interface
Modifying a Host Table Entry
Use the following procedure to modify the community name assignment or
the IP address of an entry in the Host Table.
To modify an entry in the Host Table, perform the following procedure:
1. From the bookmarks on the left side of the page, select SNMP.
The SNMP folder expands.
2. From the SNMP folder, select Host Table.
The Host Table Page is shown in Figure 82 on page 289.
3. To change the IP Address, type in the new IP address in the Host
Table.
4. To change the community name, use the pull-down menu to select a
new community name in the Host Table.
5. To activate your changes on the switch, click Apply next to the entry
that you want to modify.