Allied Telesis AT-S80 - Manual (Page 221)

AT-S80 Management Software User’s Guide
Section II: Using the Web Browser Interface 221
3. Change the IP configuration parameters by entering new information in
the fields:
System MAC Address
This parameter displays the MAC address of the switch. You cannot
change this parameter.
System IP Address
Enter the IP address for the switch.
System Subnet Mask
Enter the subnet mask for the switch.
System Default Gateway
Enter the default gateway’s IP address.
DHCP Mode
For information about setting this parameter, refer to “Enabling and
Disabling the DHCP Client” on page 225.
4. Click Apply.
Note
Changing the IP address ends your management session. To
resume managing the device, enter the new IP address of the switch
in the web browser’s URL field, as shown in Figure 52 on page 214.