Allied Telesis AT-S80 - Manual (Page 308)

Chapter 32: Rapid Spanning Tree Protocol (RSTP)
308 Section II: Web Browser Interface
The RSTP Advanced Port Configuration Page is shown in Figure 88.
Figure 88. RSTP Advanced Port Configuration Page
4. In the Admin/OperEdge column for the port you want to configure,
choose True or False to set whether or not the port will operate as an
edge port.
5. In the Admin/OperPtoP column for the port you want to configure,
choose a setting based on the information in Table 6 on page 167.
6. In the Migration column for the port you want to configure, click
Restart to reset the port.
7. Click Apply.
8. To configure all of the ports to the same settings, in the All row,
configure one, two, or all of the following settings: Admin/OperEdge,
Admin/OperPtoP, and Migration. Then click Apply.