Allied Telesis AT-S80 - Manual (Page 179)

AT-S80 Management Software User’s Guide
Section I: Using the Menus Interface 179
Configuring IP Access List
The procedures in this section describe how to enable or disable the IP
Access List Restriction feature and how to add or remove IP addresses
from the list. See the following sections:
ˆ “Enabling or Disabling IP Access List Restriction” on page 179
ˆ “Adding or Removing IP Addresses” on page 180
Enabling or
Disabling IP
Access List
Restriction
To enable or disable the IP Access List feature, perform the following
procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 26 on page
124.
2. From the Basic Switch Configuration Menu, type L to select IP Access
List.
The IP Access List Menu is shown in Figure 43.
Figure 43. IP Access List Menu
Basic Switch Configuration -> IP Access List Menu
IP Restriction: Disabled
Accessible IP Accessible IP Accessible IP Accessible IP
------------- ------------- ------------- -------------
100.10.10.4
[Q]uit to previous menu
-------------------------------------------------------------
Set IP Restriction [S]tatus
Set [I]P Address
[Q]uit to previous menu
Command>