Allied Telesis AT-S80 - Manual (Page 54)

Chapter 4: Port Configuration
54 Section I: Using the Menus Interface
Displaying the Port Parameters
To display the parameter settings for the ports on the switch, perform the
following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 4 on page 32.
2. From the Basic Switch Configuration Menu, type P to select Port
Configuration.
The Port Configuration Menu is shown in Figure 13.
Figure 13. Port Configuration Menu
The Port Configuration Menu displays the following columns of
information:
Port
The port number.
Trunk
The trunk group number. This column contains the number of the port
trunk if the port is a member of a trunk. To configure a trunk, refer to
Chapter 5, “Port Trunking” on page 61.
Basic Switch Configuration -> Port Configuration Menu
Port Trunk Type Link Status Mode Flow Ctrl
---- ----- ------ ---- ------ ---------------------
1 --- 10/100TX Up Enabled Auto (100F) Enabled
2 --- 10/100TX Up Enabled Auto (100F) Enabled
3 --- 10/100TX Up Enabled 100-FDx Enabled
4 --- 10/100TX Up Enabled Auto (10F) Enabled
5 --- 10/100TX Up Enabled Auto (100F) Enabled
6 --- 10/100TX Down Enabled Auto Enabled
7 --- 10/100TX Up Enabled Auto (100F) Enabled
8 --- 10/100TX Down Enabled Auto Enabled
9 --- 10/100TX Up Enabled Auto (100F) Enabled
10 --- 10/100TX Up Enabled 10-FDx Enabled
11 --- 10/100TX Up Enabled 10-FDx Enabled
12 --- 10/100TX Up Enabled Auto (100F) Enabled
----------------------- ------------------------------------
[N]ext Page
Set [S]tatus Set [F]low Control
[P]revious Page Set [M]ode [Q]uit to previous menu
Command>