Allied Telesis AT-S80 - Manual (Page 129)

AT-S80 Management Software User’s Guide
Section I: Using the Menus Interface 129
Creating an SNMP Host
This procedures in this section adds, removes, and modifies SNMP hosts.
Adding an SNMP
Host
To add or remove ports from a trunk, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 26 on page
124.
2. From the Basic Switch Configuration Menu, type N to select SNMP
Configuration.
The SNMP Configuration Menu is shown in Figure 27 on page 125.
3. From the SNMP Configuration Menu, type H to select Host
Configuration.
The Host Configuration Menu is displayed in Figure 29.
Figure 29. Host Configuration Menu
SNMP Configuration Menu -> Host Configuration Menu
No. IP Address Community
---- ----------- ---------------
1
2
3
4
5
6
7
8
9
10
-------------------------------------------------------------
[A]dd New Host Entry [D]elete Host Entry
[M]odify Host Entry [Q]uit to previous menu
Command>