HP XP P9500 Storage - Manual (Page 448)

Table 7-8 conf files used by the dlmsetopt utility
OS File Name
Red Hat Enterprise Linux AS4/ES4 /etc/modprobe.conf
Red Hat Enterprise Linux 5
SUSE LINUX Enterprise Server
Red Hat Enterprise Linux 6 /etc/modprobe.d/dlmdrvopt.conf
• If you use the dlmsetopt utility in an environment where an HDLM device
is used for the boot disk, after changing the settings, you need to re-
create the initial RAM disk image file. To re-create the file, use the dracut
command for Red Hat Enterprise Linux 6, and the dlmmkinitrd utility for
supporting a boot disk for other OSs. If you change the name of the initial
RAM disk image file, change the settings file for the boot loader so that
the re-created initial RAM disk image file is used during boot-up. For
details on this procedure, see Table 7-9 Setting file names for boot
loaders on page 7-38 .
Table 7-9 Setting file names for boot loaders
Boot loader File Name
LILO /etc/lilo.conf
GRUB For Red Hat Enterprise Linux /etc/grub.conf
For SUSE LINUX Enterprise Server 10 or
SUSE LINUX Enterprise Server 11
/boot/grub/menu.lst
ELILO /etc/elilo.conf
dlmstart Utility for Starting HDLM
You must perform the following operations after installing HDLM:
• Load an HDLM alert driver and a filter driver.
• Configure an HDLM device.
• Start the HDLM manager.
The dlmstart utility performs the above operations as a batch operation.
If an HDLM alert driver and a filter driver have already been loaded or the
HDLM manager is already running, the relevant operation is not performed.
Format
/opt/DynamicLinkManager/bin/dlmstart
7-38
Utility Reference
Hitachi Dynamic Link Manager User Guide (for Linux(R))