HP XP P9500 Storage - Manual (Page 287)

Root directory (/), /boot, /tmp, /usr, /var, swap
¢
When LILO is used as the boot loader:
Root directory (/), /tmp, /usr, /var, swap
¢
When LVM2 is used:
/boot
The following shows an example of the /etc/fstab file:
:
:
/dev/sddlmaa2 / ext2 defaults 1 1
:
:
3
.
Execute the HDLM-configuration definition utility (dlmcfgmgr) with the -v
parameter specified to check the correspondence between the HDLM
device and the SCSI device.
If the SCSI device name has been changed by using the udev function,
specify the -udev parameter also.
Figure 3-41 Example of Executing the dlmcfgmgr Utility with the -v
Parameter Specified on page 3-219 shows an example of executing the
dlmcfgmgr utility with the -v parameter specified. Figure 3-42 Example of
Executing the dlmcfgmgr Utility with the -v and -udev Parameters
Specified on page 3-219 shows an example of executing the dlmcfgmgr
utility with the -v and -udev parameters specified.
Figure 3-41 Example of Executing the dlmcfgmgr Utility with the -v
Parameter Specified
Figure 3-42 Example of Executing the dlmcfgmgr Utility with the -v
and -udev Parameters Specified
The HDevName, Device, and Udev columns display HDLM devices, SCSI
devices, and udev names, respectively.
4
.
Edit the /etc/fstab file.
Change the mount points for the HDLM management-target devices that
you checked in step 2 from the HDLM device to the SCSI device.
Comment out the existing HDLM device specification by placing a hash
mark (#) at the beginning of each line, and then add the SCSI device
specification as shown below, based on the correspondence between the
HDLM device and SCSI device as checked in step 3.
:
:
Creating an HDLM Environment
3-219
Hitachi Dynamic Link Manager User Guide (for Linux(R))