HP XP P9500 Storage - Manual (Page 363)

connected to the HBA port that has the specified host port number and
bus number.
Specify the host port number and bus number of the target HBA port: the
numbers are found in the PathName field displayed using the view
operation. Enter a period between these two parameter values. For
details about the view operation, see view (Displays Information) on page
6-28 .
Example
The following example shows how to place online all paths connected
to an HBA port whose host port number is 0010 and bus number is
0000:
When the confirmation message is displayed, the user enters y to
continue, or n to cancel the operation.
# /opt/DynamicLinkManager/bin/dlnkmgr online -hba 0010.0000
KAPL01057-I All the paths which pass the specified HBA will
be changed to the Online status. Is this OK? [y/n]:y
KAPL01061-I 3 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
#
-cha -pathid AutoPATH_ID
Use this parameter to place online, at one time, all the paths that pass
through a specific CHA port. The command will place online all the paths
that pass through the CHA port to which the path with the specified
AutoPATH_ID is connected.
Specify the current AutoPATH_ID of the target path, which is displayed by
using the view operation. For details about the view operation, see view
(Displays Information) on page 6-28 . Leading zeros can be omitted
(000001 and 1 indicate the same AutoPATH_ID); however, when the
target AutoPATH_ID is 000000, enter 000000 or 0 for the parameter
value.
AutoPATH_IDs are re-assigned every time the host is restarted. When you
want to add a new LU without restarting the host, AutoPATH_IDs are re-
assigned to each path of the LU when you execute the HDLM-
configuration definition utility (dlmcfgmgr). Always make sure that you
use the view operation to find the current AutoPATH_ID of the target
path, before executing the online operation.
Example
The following example shows how to place online the paths connected
to the CHA port 0A. In this example, a path whose AutoPATH_ID is
000002 is connected to the target CHA port:
When the confirmation message is displayed, the user enters y to
continue, or n to cancel the operation.
# /opt/DynamicLinkManager/bin/dlnkmgr online -cha -pathid
000002
KAPL01057-I All the paths which pass the specified CHA port
Command Reference
6-11
Hitachi Dynamic Link Manager User Guide (for Linux(R))