HP XP P9500 Storage - Manual (Page 193)

kernel /xen-pae.gz
module /vmlinuz-2.6.16.60-0.54.5-xenpae \
root=/dev/disk/by-id/scsi-SFUJITSU_MAS3735NC_A050P360007N-
part6 vga=0x317 \
resume=/dev/disk/by-id/scsi-
SFUJITSU_MAS3735NC_A050P3600077-part2 \
splash=silent showopts multipath=off
module /initrd-2.6.16.60-0.54.5-xenpae
multipath=off is set in the underlined section.
¢
When GRUB is used as the boot loader with non-Xen kernels:
For details on kernels supported by HDLM, see
Hosts and OSs
Supported by HDLM on page 3-3 .
:
:
title SUSE LINUX Enterprise Server 10 SP3
root (hd0,0)
kernel /vmlinuz-2.6.16.60-0.54.5-smp root=/dev/VG/root
vga=0x31a \
resume=/dev/VG/swap splash=silent showopts multipath=off
initrd /initrd-2.6.16.60-0.54.5-smp
multipath=off is set in the underlined section.
3
.
Check whether the definition in the /etc/fstab file contains LABEL.
Check the contents of the /etc/fstab file.
Figure 3-8 Example Content of /etc/fstab file When using LVM2 on page
3-125 shows example content of /etc/fstab file.
Figure 3-8 Example Content of /etc/fstab file When using LVM2
LABEL is set in the shaded portion.
This example assumes that IA32 uses GRUB as the boot loader. When you
use IPF that uses ELILO as the boot loader, the mount point is displayed
as /boot/efi instead of /boot (in the line where /boot is coded), and
the file system type is displayed as vfat instead of ext3.
If LABEL is not used in the /etc/fstab file, go to step 10 and install
HDLM. If LABEL is used in the /etc/fstab file, perform steps 4 to 8 to
check the mounted file system, and then remove the LABEL setting.
4
.
Execute the mount command to check the mounted file system.
Check the correspondence between the SCSI device and LABEL that you
checked in steps 3. You will need this information to remove the LABEL
setting.
Creating an HDLM Environment
3-125
Hitachi Dynamic Link Manager User Guide (for Linux(R))