HP XP P9500 Storage - Manual (Page 195)

¢
For SUSE LINUX Enterprise Server 10 or SUSE LINUX Enterprise
Server 11
Execute the udevinfo command. Specify the device name (udev
name) in the /dev/disk directory for -n.
# udevinfo -q name -n /dev/disk/by-id/scsi-2000c50fffecb6ae0-
part1
sda1
The sda1 value output is the SCSI device name corresponding to /
dev/disk/by-id/scsi-2000c50fffecb6ae0-part1.
6
.
Edit the /etc/fstab file to remove the LABEL setting.
The detailed procedure is explained in steps 7 and 8.
Figure 3-10 Example of Editing /etc/fstab file on page 3-127 shows an
example of editing the /etc/fstab file.
Figure 3-10 Example of Editing /etc/fstab file
Comment out the LABEL line, and then add the shaded line.
This example assumes that IA32 uses GRUB as the boot loader. When you
use IPF that uses ELILO as the boot loader, the mount point is displayed
as /boot/efi instead of /boot (in the line where /boot is coded), and
the file system type is displayed as vfat instead of ext3.
7
.
If necessary, back up the /etc/fstab file.
8
.
Edit the /etc/fstab file.
Refer to the correspondence between LABEL and the SCSI device that you
checked in step 4.
Copy the registration of the LABEL specification.
Comment out the existing settings.
Edit the file to disable the LABEL specification and enable the SCSI device
specification.
9
.
Restart the host to make sure that booting from the SCSI device is
possible.
This completes the removal of the LABEL setting.
10
.
Install HDLM.
To install HDLM, see
Performing a New Installation of HDLM on page 3-79
perform steps 2 to 12 to create an HDLM device. You will also need to
perform step 13 if you are only restarting the host. Note that the
Creating an HDLM Environment
3-127
Hitachi Dynamic Link Manager User Guide (for Linux(R))