HP XP P9500 Storage User Manual
Page 152
For details on setting the cluster software, see
,
Settings for Oracle RAC on page 3-178
,
Settings for VCS on page 3-183
.
20
.
Execute the dlnkmgr command's view operation to check the HDLM
settings and status of each program.
The following is an example of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster :
Elog Level : 3
Elog File Size (KB) : 9900
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(1)
Reservation Status :
Intermittent Error Monitor : off
HDLM Manager Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss 1000
HDLM Driver Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd
#
Even when cluster software is being used, Support Cluster is blank.
However, the cluster function is operating normally.
21
.
Check that the correct version of HDLM is installed.
If HDLM version x.x.x-xx is displayed, the installed HDLM version is
correct. x.x.x-xx is the version of the installed HDLM.
22
.
Check that the programs are running properly.
If HDLM Manager, HDLM Alert Driver, and HDLM Driver are all Alive, all
programs are running correctly.
If the programs are not running properly, see
, and then take actions.
After the installation, check the path configuration according to the procedure
Checking the Path Configuration on page 3-183
.
Preparations for an Upgrade Installation or Re-installation of HDLM
This section describes the preparations required before performing an
upgrade installation or re-installation of HDLM.
3-84
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Linux(R))