HP Storage Mirroring Software - Manual (Page 668)

666 of 739
Using the Target Data Verification (TDV) utility
If you have not done so already, launch the Storage Mirroring Recover Application
Manager by selecting Start, Programs, HP Storage Mirroring, Recover, Storage Mirroring
Recover Application Manager.
There are several options available in the Target Data Verification utility for performing a
verification of the target data. The functions in this utility allow you to use a command
line interface to perform the same target data verification tests that you can using the
Application Manager interface. These options and the full command syntax are
described in the following tables.
Note:
In the following syntax descriptions, < > denotes a required parameter. [ ]
denotes an optional parameter.
Target Data Verification Utility Command Syntax for Exchange
Command tdv
Description
Used to run a test that verifies that the database on the target is viable for
failover
Syntax
tdv [/apptype ] >
> > [/port ]
[/username ] [/password ]
> [/addonsvc ]
[/setpassword ] [/getpassword]
[/scriptpost ] [/scriptpre ]
> >
[/interactive] [/?] | [/help]