HP Storage Mirroring Software User Manual
Page 231
229 of 739
based on your operating system/SharePoint configuration. You should only modify this
selection if there are additional services that need to be started along with SharePoint
during the failover/failback process.
Modifying the default configuration for services may affect whether data can be
successfully replicated. Do not modify the services to start/stop unless you are very
familiar with Storage Mirroring Recover and SharePoint.
1. To add a service, click Add. The Add Service window will appear.
2. Select the Service name from the drop-down box, then click Add; or, type the
name of a service, then press Enter.
3. If available, select the Service must be stopped on target checkbox. Most
services must be stopped on the target for replication to occur properly.
4. When you are finished entering services, click Close to return to the Failover
configuration window.
5. To remove a service, select one or more services, then click Remove.
You can remove all of the services besides the required SQL server service
(MSSQLSERVER for a default instance, or MSSQL$
named instance).
6. Services will be started in the displayed order (top-to-bottom starting with the left
column) and shutdown in reverse order (bottom-to-top starting with the right
column). To re-arrange the order in which services are started/stopped:
a. Add any additional services.
b. Select a service in the list, then use the up and down arrow buttons to move
the service to the appropriate position in startup/shutdown order.
Add/remove SharePoint services
To stop the target SharePoint services when protection is enabled, click the Add
SharePoint Services button. SharePoint services will be added to the list of services.
Note:
If you add SharePoint services, they will be started upon failover and stopped
upon failback. This will result in SharePoint on the target being active only
when the target is failed over.
Next step: