Optional full-server protection settings, Including and excluding data to be protected – HP Storage Mirroring Software User Manual

Page 128

126 of 739

to click Fix or Fix All and let Storage Mirroring Recover correct the problem for you.
For those errors that Storage Mirroring Recover cannot correct automatically, you
will need to modify the target to correct the error, or you can select a different target.
You must revalidate the selected servers until the validation check passes without
errors.

7. Once the validation check passes without errors, click Enable Protection to begin

monitoring.

Note:

If you have a full-server protection connection established, do not create any
other Storage Mirroring Recoverconnections from or to the source or target.

If you are using a cluster, you must manually alter the disk signature before or
after failover. See the

Microsoft Knowledge Base article 280425

for details on

how to change the disk signature. You can automate the disk signature
alteration as part of failover

using the pre- or post-failover scripts

Optional full-server protection settings

Optional protection settings are available when configuring a full-server protection
connection, but they are not required. If you want to configure the optional settings, make
sure you have a valid source and target specified, then click Configure protection from
the main Full-Server Failover Manager page.

You have the following optional configuration settings available.

●

Including and excluding data to be protected

●

Stopping services on the target when protection is enabled

●

Taking snapshots of the target

●

Configuring failover monitoring and processing

●

Mapping network configuration on the target for post-failover

●