HP Storage Mirroring Software - Manual (Page 402)

400 of 739
Replication
Status
Description
Restoring Data is being restored from the target to the source
Transmitting Data is being sent to the target machine
(Unknown) Replication status could not be determined
The following table identifies the possible transmit modes.
Transmit Mode Description
Started The mirror or replication has been started
Paused The mirror or replication has been paused
Warning (see details) A warning condition has been encountered
The following table identifies the possible target status states.
Target
Status
Description
Online The target machine is active and online
Mirroring
The target is in the middle of a mirror process. The data will not be in a
good state until the mirror is complete.
Mirroring
Stopped
The mirroring process has been stopped
Re-mirror
required
The data on the target is not in a good state because a remirror is
required. This may be caused by an incomplete or stopped mirror or an
operation may have been dropped on the target.
Retrying The target machine is retrying operations for the connection
Paused The target machine is paused by user intervention
Pausing The connection is in the process of pausing
Restore
Required
The data on the source and target do not match because of a failover
condition. Restore the data from the target back to the source. If you want
to discard the changes on the target, you can remirror to resynchronize
the source and target.
Target Status States