Configuring sql protection settings, Configure protection settings – HP Storage Mirroring Software User Manual
Page 173
171 of 739
You may enter a user name for a different domain by entering a fully-qualified user
name. The fully-qualified user name must be in the format domain\username or
username@domain. If you enter a non-qualified name, the DNS domain will be used.
Entering the credentials for the logged-on user may be valid.
The Application Manager will attempt to use the same user name and password the next
time you select a server.
Using clustered SQL servers
SQL servers are selectable in the same way as physical servers; however, physical
servers that are members of a cluster (called a “node”) are not shown in the server drop-
down list.
Next step:
Configuring SQL protection settings
If you have not done so already, launch the
Protecting a SQL Server workflow
To change the default SQL configuration parameters, make sure you have selected a
valid source and target, then click Configure from the Manage SQL page. The
Configure Protection window will appear
The Configure Protection window has tabs for configuring:
●
●
●
●
●
Note:
If any important aspect of your configuration changes (for example, service
account name change, server IP address change, server logical drive
configuration change, recently added server hardware), you should reconfigure
protection and, if possible, not re-use the existing configuration in order to
capture the new configuration.
If you do not need to change the configuration settings,
, then
enable protection.
If you have already enabled protection for a connection and need to change the
configuration parameters, you will first need to
.