GW Instek GSP-930 Programming Manual - Manual (Page 61)

REMOTE CONTROL
59
SCPI Commands
*CLS .......................................................................................... 59
*IDN? ....................................................................................... 59
*ESE .......................................................................................... 60
*ESR? ........................................................................................ 60
*OPC ......................................................................................... 60
*RST .......................................................................................... 61
*SRE .......................................................................................... 61
*STB? ........................................................................................ 61
*TST? ........................................................................................ 61
*WAI ......................................................................................... 62
*CLS
Set
Description The *CLS command clears the Standard Event
Status, Operation Status and Questionable Status
registers. The corresponding Enable registers in
each of the above registers are not cleared.
If a newline code immediately precedes a
*CLS command, the Error Que and the MAV bit in
the Status Byte Register is also cleared.
Syntax *CLS
*IDN?
Query
Description Queries the manufacturer, model number, serial
number, and firmware version of the instrument.
Query Syntax *IDN?
Return parameter Returns the instrument identification as a
string in the following format:
GWINSTEK,GSP-930, XXXXXXXXXXXX,V.X.X.X.X
Manufacturer: GWINSTEK
Model number : GSP-930
Serial number : XXXXXXXXXXXX
Firmware version : V.X.X.X.X