GW Instek GSP-930 Programming Manual - Manual (Page 103)

REMOTE CONTROL
101
:DISPlay[:WINDow]:SPECtrogram
Set
Description Sets the display window to spectrogram mode.
Syntax :DISPlay[:WINDow]:SPECtrogram
Example :DISP:SPEC
:DISPlay[:WINDow]:SPLit:NORMal:
ALTernate
Set
Description Turns on the Alternate Sweep function for split
window mode, both windows are in the normal
trace mode.
(we also have Spectrogram and Topographic
mode)
Syntax :DISPlay[:WINDow]:SPLit:NORMal:ALTernate
Example :DISP:SPL:NORM:ALT
:DISPlay[:WINDow]:SPLit:NORMal:ACTive
Set
Description Sets which window (upper or lower) to display the
normal trace mode in. It also becomes the active
window. This command will also put the screen
into split-screen mode if it is not already.
Syntax :DISPlay[:WINDow]:SPLit:NORMal:ACTive
{UPPer|LOWer}
Example :DISP:SPL:NORM:ACT UPP
:DISPlay[:WINDow]:SPLit:SPECtrogram
Set
Description Sets the split screen mode to Spectrogram +
Spectrum.
Syntax :DISPlay[:WINDow]:SPLit:SPECtrogram