GW Instek GSP-930 Programming Manual - Manual (Page 113)

REMOTE CONTROL
111
:MMEMory:CDIRectory
Set
Description Sets the source directory for memory related
commands.
When you use a single USB drive/SD card with
multiple partitions inside, the system will
automatically name these partitions in the numeric
order, so you need to specify the partition number.
The same situation applies when you use a USB
hub to extend the number of USB ports. When a
hub is used, all the partitions from all the attached
devices are numbered in numerical order from the
first port to the last port.
If a partition number is not supplied, the system
will default to partition #1. For example:
:MMEM:CDI USB0 = :MMEM:CDI USB)
Syntax :MMEMory:CDIRectory {LOCAL|USB[]|SD[]}
Parameter LOCAL
USB
SD
Example1 :MMEM:CDIR USB
Example2 :MMEM:CDIR USB3
:MMEMory:COPY
Set
Description Copies a designated file from the current file
directory to the destination directory. The file can
be renamed after it is copied.
Syntax :MMEMory:COPY ,
Parameter
Example :MMEM:COPY quick1.jpg,quick2.jpg