GW Instek GSP-930 Programming Manual - Manual (Page 26)

GSP-930 Programming Manual
24
Interface Configuration
Configure to USB Remote Interface
USB
configuration
PC side
connector
Type A, host
GSP side
connector
Rear panel Type B, slave
Speed
1.1/2.0 (full speed/high speed)
USB Class
USB TMC (USB T&M class)
Note
Before communication with the GSP-930 via the
USB interface, make sure NI-Visa has been
properly installed on the PC beforehand.
(NI-Visa 3.0 or above supports USB TMC)
Panel operation 1. Connect the USB cable to the rear
panel USB B port.
2. Press
System
>More 1/2[F7]>RmtInterface
Config[F2]>USB Mode and toggle the USB mode
to Device.
Note
It may take a few moments to switch USB modes.
Configure GPIB Interface
To use GPIB, the optional GPIB port must be installed.
Configure GPIB 1. Ensure the spectrum anlayzer is off before
proceeding.