GW Instek GSP-930 Programming Manual - Manual (Page 28)

GSP-930 Programming Manual
26
Connection Connect an Ethernet cable from
the network to the rear panel LAN
port.
Settings 1. Press
System
>More 1/2[F7]>RmtInterface>
LAN[F2]>LAN Config[F1] to set the LAN
settings:
IP Address[F1] Sets the IP address.
Subnet Mask[F2] Sets the subnet mask.
Default
Gateway[F3]
Sets the default gateway.
DNS Server[F4] Sets the DNS server address
LAN Config[F5] Toggles the LAN
configuration between DHCP
and manual settings.
2. Press Apply[F6] to confirm the LAN
configuration settings.
Display Icon The LXI icon turns green when connected
to a LAN and will flash if the
“Identification” setting is on, see page 31.
Set Password The password on the LXI webpage can be set
from the spectrum analyzer. The password is
shown in the system information.
By default the password is set to: lxiWNpwd
3. Press
System
>More 1/2[F7]>RmtInterface
Config[F2]>LAN[F2]>LXIPassword[F2] to set
the password.