Lincoln Electric IM8000 CHECKPOINT - Manual (Page 95)

Overview Reports Chapter 7. Summary Tab – Container Level
IM8000 CheckPoint™ User Manual 7.7
Productivity
The Productivity graphs provide an overview of the number of welds made during the time period you
select (Figure 7.5) and breaks them into categories:
ƒ Without Limit: CheckPoint™ includes in this category any welds performed during the selected
time period that did not have WeldScore™ or other limit enabled when it was performed.
ƒ Out of Limit: Of the total number of welds performed (during the selected time period), this
percentage represents the number of those welds that went outside of the limits set for the
weld.
ƒ In Limit: Of the total number of welds performed (during the selected time period), this
percentage represents the number of those welds that were within the limits set for the weld.
Figure 7.5 Productivity
The pie chart breaks down the number of welds made during the time period into categories and displays
the percentage of total welds in each category. The bar graph shows the total number of welds performed
during the time period selected, as well as how many of those welds were within limits or out of limits.
For example, Advanced Manufacturing performed 10,000 welds over the course of 24 hours. Of those
10,000 welds, 2000 had no limits set, 500 were outside the limits set for them and 7500 were within limits.
Therefore, the Productivity pie chart displays a slice for 20% Without Limit, 5% Out of Limit, and 75% In
Limit.