Lincoln Electric IM8000 CHECKPOINT - Manual (Page 107)

Today Chapter 8. Summary Tab – Power Source Level
IM8000 CheckPoint™ User Manual 8.9
Field Description
Weldset CS The Weldset CS (or checksum) provides programmers a way to determine if any
accidental changes occurred in the programming. It gives them a way to verify if
there was an error in the code.
Ethernet IP This is the network address to this specific Welding Power Source. You can use this
information to connect to the Welding Power Source using Power Wave® Manager.
Ethernet DHCP Dynamic Host Configuration Protocol (DHCP) allows network devices to
automatically obtain a valid IP address from a server. If this field displays True, this
Welding Power Source can automatically configure its IP address from the network.
If this field displays False, the power source does not have that ability.
PM Revision The Production Monitoring™ revision number provides support personnel with the
formatting used for the weld records produced by the Welding Power Source.
Productivity (Last 24 Hours)
The Productivity (Last 24 Hours) widget provides an overview of the number of welds made in the last 24
hours (Figure 8.10) on the Welding Power Source selected in the Asset Tree. The bar graph shows the total
number of welds performed over the last 24 hours, as well as how many of those welds were within limits
or out of limits.
Figure 8.10 Productivity (Last 24 Hours)