Lincoln Electric IM8000 CHECKPOINT - Manual (Page 156)

Chapter 13. Events Tab Report Criteria
13.2 CheckPoint™ User Manual IM8000
Report Criteria
The criteria available for the Events reports allow you to customize the reports to meet your needs. The
criteria for both reports are the same. For more in-depth information on report criteria in general, please
see page 6.4.
Figure 13.1 Criteria for the Events Reports
To set the criteria, simply click the Criteria link to open the Criteria window (Figure 13.1) and make your
selections. Click Save and the graph updates to reflect the appropriate information for you, depending on
the Welding Power Source or the Container you have selected in the Asset Tree. Table 13.1 explains the
criteria in more detail.
Table 13.1 Criteria Available on the Events Reports
Field Description
Start Date and
End Date Select a date range in which the event(s) occurred to display the data you want to
review. Event(s) that occurred within this date range (that also meet all other criteria
you select) appear in the resulting report.
TIP | You can type the date into the field, or you can click the calendar icon ( )
next to the field to display an interactive calendar where you can click on the date you
want. Use the arrow icons ( and ) to navigate to previous or future months. The
double arrow icons ( and ) move forward and backward by three-month intervals.
Event Log Type To view only those events of a specific category, you can select that type of event from
the Event Log Type drop-down. Page 13.1 explains these in a little more detail. If you
want to display all events that occur, select All from the drop down menu.
Record Count If you want to restrict the size of the report, you can tell CheckPoint™ to limit the
number of events that appear in the report. Select that maximum number of events
from the Record Count drop-down.
STOP | If you set the Record Count to No Limit, the report could take over several
minutes to generate, depending on the time frame you select.
NOTE | If the resulting report contains more records than you indicated in the
Record Count field, the system does not show the remaining records. Be sure your
limit is inclusive of all your data.