Lincoln Electric IM8000 CHECKPOINT - Manual (Page 93)

Operator Reports Chapter 7. Summary Tab – Container Level
IM8000 CheckPoint™ User Manual 7.5
Table 7.2 Columns on the Operator Reports
Column Description
Operator ID When an operator begins welding on a power source, his or her ID or badge
number is entered through Power Wave® Manager or another method. This
column represents that operator’s ID.
TIP | The information displayed in CheckPoint™ is for all the welders in the
Container you have selected in the Asset Tree.
Welds This displays the total number of individual welds performed by the Operator
over the time period selected during the selected shift (if specified) for all the
welders in the Container you have selected in the Asset Tree.
Welds Out of Limits The number in the Welds Out of Limits column reflects the number of welds
performed that went outside of the limits set for the Weld Profile used for the
weld.
The percentage next to the number of welds is the percentage that this
number represents of the total number of welds where limits were enabled,
including those welds that were within the limits set.
NOTE | If no Weld Profile limits were enabled for the welds performed, the
Welds Out of Limits column displays a zero.
For example, the Welds column displays 62 welds and 50 of those welds had
had limits enabled when they were performed. Of those 50 welds, 15 were
outside of those limits, which also equates to 30% of the 50 welds. The Welds
Out of Limits column would display 15 (30.00%).
WeldScore™ This column displays the average WeldScore™ for the welds listed in the Welds
column where WeldScore™ was enabled. If WeldScore™ was not enabled for a
weld, it is not taken into consideration for this column. If none of the welds in
the Welds column had WeldScore™ enabled, the WeldScore™ column is empty.
For example, if the Welds column displays 62 welds and 42 of those welds had
WeldScore™ enabled when they were performed, the WeldScore™ column
shows the average WeldScore™ for the 42 welds.
Arc Time (min) This displays the total number of minutes that the Operator spent welding
based on the welds listed in the Welds column over the time period selected
during the selected shift (if specified).
Deposition (lb) This column displays the amount of wire (in pounds or kilograms) that was
deposited for the welds made over the time period selected during the
selected shift (if specified).
Time Of Last Weld This is the start time and date of the most recent weld performed by the
Operator, regardless of the time period selected. If the Welding Power Source
is currently active, CheckPoint™ displays “Welding”.