Lincoln Electric IM8000 CHECKPOINT - Manual (Page 62)

Chapter 4. Managing CheckPoint™ Welding Power Sources
4.22 CheckPoint™ User Manual IM8000
Figure 4.21 Adding a New Welding Power Source
To add a Welding Power Source to CheckPoint™:
Procedure Details
1. Click the New Welder button on the
Welders tab.
The Welder Definition page displays.
2. Enter the Welder Name and Welder
Description.
Welder Name: The text you enter here appears as
the entry in the Asset Tree (Figure 4.21). Be sure
to use an easily recognizable name.
Welder Description: The text here briefly explains
to which Welding Power Source this entry refers
and is helpful when viewing the list of welders in
the CheckPoint™ Manager.
3. Click the Select button next to the Installation
File field.
4. Navigate to the installation key file for this
Welding Power Source and click Open.
Please refer to page 2.10 for details on saving the
installation key file using Power Wave® Manager.
5. Click the Save button. The Welding Power Source entry appears in the
list of welders in the CheckPoint™ Manager.
NOTE | Information from the Welding Power
Source may not be available for 15 minutes. If it
is not available, be patient. Do not delete it and
attempt to add it again. This will cause a longer
delay.